[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 01
www.cobra.it
NISSAN
MOD.
X-TRAIL*
YEAR.
02
fi
PETROL
DIESEL
X
MAKE
* Models with original equipment keyless entry system.
ALARM/SIREN
POSITION
Position the compact alarms and the sirens in the driver’s side wheelhouse, near the
battery.
CENTRAL UNIT POSITION
Position the modular system and the modules under the driver’s side dashboard.
POWER SUPPLY
+30:
Connect with a cable terminal to the clamp marked ‘+30’ located in the general
supply wiring placed in the black box on the side of the battery, in the engine
compartment.
-31:
Connect with a cable terminal directly to the car body.
IGNITION WIRE
+ 15/54:
connect to the GREEN wire, with 2 ORANGE references, located in the wiring
harness coming out of the 20 way grey connector placed on the coming out of the white
central locking unit fixed behind the driver’s side glove compartment.
DIRECTION INDICATORS
Connect to the GREEN/BLACK wire with 2 ORANGE references and to the
GREEN/YELLOW wire with 2 ORANGE references, located in the wiring harness
coming out of the first 10 way white connector, under the driver’s side glove
compartment.
ELECTRIC WINDOWS
Negative control signal
Front window, driver’s side:
cut the GREEN/BLACK wire located in the wiring harness coming out of the 16 way
white connector, directly inside the driver’s side door.
Front window, passenger’s side:
cut the RED/WHITE wire located in the wiring harness of the 14 way brown connector
coming out of the driver’s side door.
Rear window, driver’s side:
cut the GREEN/WHITE wire located in the wiring harness of the 14 way brown
connector coming out of the driver’s side door.
Rear window, passengers’ side:
cut the RED/YELLOW wire located in the wiring harness of the 14 way brown connector
coming out of the driver’s side door.
ACTIVAT./DEACTIVATION
CONTROLS
Connection vehicle/3800 antithefts
Refer to the
diagram nr.134.
IMMOBILISATION POINT
Fuel pump
Cut the BLACK/YELLOW wire located in the wiring harness coming out of the connector
of the blue relay placed behind the driver’s side bulkhead.
STARTER
+50:
Cut the BLACK/WHITE wire located in the wiring harness coming out of the 6 way
white connector, directly coming out of the ignition key.
BONNET SWITCH
Install an additional switch on the headlamp support plate, driver’s side.
DOORS AND BOOT SWITCH
Connect to the RED/YELLOW wire at the position nr.1 of the 20 way grey connector
located on the coming out of the white central locking unit fixed behind the driver’s side
glove compartment.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
nixtr02gbbtr1.doc
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 01
www.cobra.it
FITTING DIAGRAM N°134
Diagram to connect the 3800 serie antithefts on
NISSAN X-TRAIL
3800 serie
VIOLET/WHITE
+30
ORANGE/WHITE
8 way brown connector
(black receiving central on VIOLET
the back of driver’s side
glove compartment
)
ORANGE
Diode 1N5406 BLACK/GREEN
20 way grey connector
(white locking central under GREY/BLACK YELLOW/BLACK
driver’s side glove comp.)
RED/BLACK pos. 11
M
BLUE pos. 14
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
nixtr02gbbtr1.doc
[ Pobierz całość w formacie PDF ]