[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
MAKE
NISSAN
MOD.
ALMERA*
YEAR.
01
fi
PETROL
DIESEL
X
* Models with original equipment keyless entry system.
ALARM/SIREN
POSITION
Position the compact alarms and the sirens in the engine compartment, passenger’s side. Pass the
cables using the original core hitch.
CENTRAL UNIT POSITION
The modular systems and the modules should be positioned under the driver’s side dashboard.
POWER SUPPLY
+30:
connect to the 2 mm
2
WHITE wire located in the wiring harness coming out of the connector of
the central doors locking unit placed on the right of the steering column, under the dashboard.
-31:
connect directly to the 2 mm
2
BLACK wire located in the wiring harness coming out of the
connector of the central doors locking unit placed on the right of the steering column, under the
dashboard.
IGNITION WIRE
+15/54:
Connect to the 1,5 mm
2
BLUE wire located in the wiring harness coming out of the connector
of the central doors locking unit placed on the right of the steering column, under the dashboard.
DIRECTION INDICATORS
Connect to the BLACK/GREEN wire with SILVER references and to the YELLOW/GREEN wire with
SILVER references located in the wiring harness coming out of the
central doors locking unit placed
on the right of the steering column, under the dashboard.
ELECTRIC WINDOWS
Positive control signal
Front window, driver’s side:
cut the the GREEN/RED wire.
Front window, passenger’s side:
cut the RED/WHITE wire.
Rear window, driver’s side:
Cut the YELLOW wire.
Rear window, passenger’s side:
cut the GREEN/WHITE wire.
These connections must be done in the wiring harness coming out of the connector of the original
push-button panel, in the driver’s side door.
ACTIVAT./DEACTIVATION
CONTROLS
Connections antitheft/vehicle
Art.3800 Vehicle Position
GREY/BLACK WHITE/BLACK (Motor ) on the coming out of the central unit
YELLOW/BLACK RED/BLACK (Motor) on the coming out of the central unit
VIOLET/WHITE ground car body
ORANGE GREEN/BLACK (BLK) on the coming out of the central unit
VIOLET YELLOW/GREEN (BLK) on the coming out of the central unit
ORANGE/WHITE ground ground
All the connections mentioned above are in the coming out of the central doors locking unit
located on the right of the steering column, under the driver’s side dashboard.
IMMOBILISATION POINT
Gasoil pump
Cut the BROWN wire with SILVER references located in the wiring harness coming out of the 16 way
white connector, in the fuse box, under the driver’s side dashboard.
STARTER
+50:
Cut the BLACK/WHITE wire located in the connector of the ignition key.
BONNET SWITCH
Install an additional switch on the front headlamp support grill, driver’s side.
DOORS SWITCH
Connect to the 1mm
2
RED/WHITE wire located in the wiring harness coming out of the connector of
the central doors loking unit placed on the right of the steering column, under the dashboard.
BOOT SWITCH
Connect to the 1 mm
2
BLACK/WHITE wire located in the wiring harnes coming out of the connector
of the rear lamp. Install a diode.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
nialm01gbdt.doc
[ Pobierz całość w formacie PDF ]