[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
NISSAN
MOD.
X-TRAIL
YEAR.
02
fi
PETROL
DIESEL
X
MAKE
ALARM/SIREN
POSITION
Position the compact alarms and the sirens in the driver’s side wheelhouse, near the
battery.
CENTRAL UNIT POSITION
Position the modular system and the modules under the driver’s side dashboard.
POWER SUPPLY
+30:
Connect with a cable terminal to the clamp marked ‘+30’ located in the general
supply wiring placed in the black box on the side of the battery, in the engine
compartment.
-31:
Connect with a cable terminal directly to the car body.
IGNITION WIRE
+ 15/54:
connect to the GREEN wire, with 2 ORANGE references, located in the wiring
harness coming out of the 20 way grey connector placed on the coming out of the white
central locking unit fixed behind the driver’s side glove compartment.
DIRECTION INDICATORS
Connect to the GREEN/BLACK wire with 2 ORANGE references and to the
GREEN/YELLOW wire with 2 ORANGE references, located in the wiring harness coming
out of the first 10 way white connector, under the driver’s side glove compartment.
ELECTRIC WINDOWS
Negative control signal
Front window, driver’s side:
cut the GREEN/BLACK wire located in the wiring harness coming out of the 16 way white
connector, directly inside the driver’s side door.
Front window, passenger’s side:
cut the RED/WHITE wire located in the wiring harness of the 14 way brown connector
coming out of the driver’s side door.
Rear window, driver’s side:
cut the GREEN/WHITE wire located in the wiring harness of the 14 way brown connector
coming out of the driver’s side door.
Rear window, passengers’ side:
cut the RED/YELLOW wire located in the wiring harness of the 14 way brown connector
coming out of the driver’s side door.
CENTRAL DOORS LOCKING
Negative control signal
Connect to the GREEN/RED wire at the position nr.3 (lock) and to the VIOLET wire at the
position nr.4 (unlock) located in the 20 way grey connector coming out of the white
central locking unit fixed behind the driver’s side glove compartment.
IMMOBILISATION POINT
Fuel pump
Cut the BLACK/YELLOW wire located in the wiring harness coming out of the connector
of the blue relay placed behind the driver’s side bulkhead.
STARTER
+50:
Cut the BLACK/WHITE wire located in the wiring harness coming out of the 6 way
white connector, directly coming out of the ignition key.
BONNET SWITCH
Install an additional switch on the headlamp support plate, driver’s side.
DOORS SWITCH
Connect to the RED/YELLOW wire at the position nr.1 of the 20 way grey connector
located on the coming out of the white central locking unit fixed behind the driver’s side
glove compartment.
BOOT SWITCH
The boot protection is obtained making the connection of the doors perimetrical
protection.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
nixtr02gbb.doc
[ Pobierz całość w formacie PDF ]