[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
NISSAN
MOD.
MICRA
YEAR
98
fi
PETROL
DIESEL
X
MAKE
ALARM/SIREN
POSITION
Position the compact alarms and the sirens in the engine compartment, near the
bulkhead that divides the engine compartment and the windshield wiper zone.
Alternatively, on the bulkhead of the wing behind the passenger’s side headlamp.
Pass the cables through one of the original core hitches located on the passenger’s
side panel.
POWER SUPPLY
+30:
Connect to the 4 mm
2
WHITE/RED wire located in the wiring harness coming
out of the 3 way black connector, in the fuse box.
- 31:
Connect with a cable terminal to one of the original power supply pins located
under the left lateral dashboard, driver’s side.
IGNITION WIRE
+ 15/54:
connect to the 1,5 mm
2
BLUE/GREEN wire located in the wiring harness
coming out of a multiway white connector at the rear of the fuse box.
DIRECTION INDICATORS
Connect to the 1 mm
2
GREEN/YELLOW wire with GREY references and
GREEN/BLACK wire with GREY references located in the wiring harness coming
out of the emergency blinker switch in the central part of the dashboard.
ELECTRIC WINDOWS
Positive control signal
Front window, driver’s side:
cut the 2 mm
2
RED/BLUE wire directly in the wiring harness coming out of the
connector of the relevant original switch.
Front window, passenger’s side:
cut the 2 mm
2
BLUE/RED wire located in the wiring harness coming out of the input
connector of the driver’s side door.
CENTRAL DOORS LOCKING
Negative control signal
It is necessary to refer to the
diagram nr. 41
to obtain the central doors locking.
IMMOBILISATION POINT 1
Fuel pump
Cut the 1,5 mm
2
BROWN wire with GREY references in the wiring harness located
under the fuse box, on the left, under the driver’s side dashboard.
IMMOBILISATION POINT 2
Additional motor cut
Cut the 1,5 mm
2
PINK wire with GREY reference located in the wiring harness
coming out of a multiway connector in the fuse box.
STARTER
+ 50:
Cut the BLACK/RED wire located in the wiring harness coming out of the red
connector behind the left lateral panel, driver’s side.
BONNET SWITCH
Install an additional switch in the already existing holes on the left and right sides of
the front headlamp support plate, near the original rubber of the bonnet doorstop.
DOORS SWITCH
Connect to the 1 mm
2
WHITE/RED wire located in the wiring harness coming out of
the white connector (on the right) of the central doors locking unit that is installed on
the left under the dashboard, driver’s side.
BOOT SWITCH
Connect to the 1 mm
2
BLUE wire located in the wiring harness coming out of the 2
way connector of the boot lamp.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
nimic98gbb.doc
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
FITTING DIAGRAM N° 41
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
nimic98gbb.doc
[ Pobierz całość w formacie PDF ]