[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
NISSAN
MOD.
PRIMERA*
YEAR.
01
fi
PETROL
DIESEL
X
MAKE
* Models with original equipment keyless entry system.
ALARM/SIREN
POSITION
Position the compact alarms and the sirens on the support of the passenger’s side shock absorber,
in the engine compartment. Pass the cables using the original rubber core hitch located in the panel
that divides the engine compartment and the passenger’s compartment .
CENTRAL UNIT POSITION
Position the modular systems and the modules under the driver’s side dashboard.
POWER SUPPLY
+ 30:
connect directly to the 4mm
2
WHITE/BLUE wire located in the 6 way WHITE connector placed
in the fuse box.
- 31:
connect directly to the car body.
IGNITION WIRE
+ 15/54:
connect to the 2 mm
2
RED/BLACK wire in the 6 way white connector located in the fuse
box.
DIRECTION INDICATORS
Connect to the GREEN/BLACK wire with SILVER reference and to the GREEN/YELLOW wire with
SILVER reference located in the 16 way white connector, in the fuse box.
ELECTRIC WINDOWS
Positive control signal
Front window, driver’s side:
Cut the RED/WHITE wire coming out of the push botton panel inside the driver’s side door.
Front window, passenger’s side:
Cut the BLUE wire.
Rear window, driver’s side:
Cut the GREEN/WHITE wire.
Rear window, passenger’s side:
Cut the YELLOW/RED wire.
All the connections mentioned above must be done in the wiring harness coming out of the 12 way
driver’s side door.
ACTIVAT./DEACTIVATION
CONTROLS
Connections antitheft/vehicle
38XX Vehicle Position
YELLOW/BLACK GREY/GREEN 10 way connector
GREY/BLACK GREEN/RED 10 way connector
VIOLET ground car body
ORANGE ground car body
VIOLET/WHITE ground car body
ORANGE/WHITE ground car body
These connections must be done in the 10 way connector coming out of the central in the fuse box.
Note:
The alarm system activates with the original radio control and with the key on the driver’s side
door but will deactivate with the original radio control only.
IMMOBILISATION POINT
Fuel pump
Cut the GREEN wire with SILVER references located in the 8 way white connector coming out of the
central fixed to the ignition key.
STARTER
+ 50:
Cut the WHITE/GREEN wire located in the wiring harness coming out of the 16 way white
connector, in the fuse box.
BONNET SWITCH
Install an additional switch on the front headlamp support plate, driver’s side.
DOORS SWITCH
Connect to the RED wire located in the wiring harness coming out of the switch of the driver’s side
door.
BOOT SWITCH
Connect to the RED/BLUE wire coming out of the 20 way white connector. It is suggested to put on
a diode on the original line.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
nipri01gbbt.doc
[ Pobierz całość w formacie PDF ]