[ Pobierz całość w formacie PDF ]
SPECIFIC VEHICLE ALARM FITTING INSTRUCTIONS REV. 00
www.cobra.it
NISSAN
MOD.
PRIMERA
YEAR
97
fi
PETROL
DIESEL
X
MAKE
ALARM/SIREN
POSITION
Position the compact alarms and the sirens in the engine compartment, on the shock
absorber pillar on the driver’s side.
POWER SUPPLY
+30:
connect to the 4 mm
2
RED wire in the general supply wiring of the fuse box.
- 31:
connect with a cable-end connector to one of the ground terminals behind the left
lateral bulkhead on the driver’s side.
IGNITION WIRE
+15/54:
connect to the 2 mm
2
RED wire with WHITE references that comes out of the 6
way connector,behind the fuse box
DIRECTION INDICATORS
Connect to the 1 mm
2
GREEN/YELLOW wire with SILVER references and
GREEN/BLACK wire with SILVER references in the wiring harness coming out of the 8
way brown connector, next to the fuse box.
ELECTRIC WINDOWS
Positive control signal
Front window, driver’s side:
cut the WHITE/RED wire inside the driver’s door.
Front window, passenger’s side:
cut the 2 mm
2
GREEN wire that comes out of the driver’s door.
Rear window, driver’s side:
cut the 2 mm
2
GREEN/BLACK wire that comes out of the door.
Rear window, passenger’s side:
cut the 2 mm
2
GREEN/BLACK wire that comes out of the door.
These wires are located in the wiring harness coming out of the respective switch.
CENTRAL DOORS LOCKING Negative control signal
Connect to the 1 mm
2
LIGHT GREEN/RED wire with a GREY dash (lock) and to the
ORANGE wire with a GREY dash (unlock) located in the wiring harness that comes out
of the central locking unit, behind the left panel, driver’s side.
IMMOBILISATION POINT
Fuel pump relay
Cut the 0,5 mm
2
BLACK/WHITE wire with SILVER
references located in the wiring
harness that comes out of the light blue fuel pump relay, on the right, in the fuse box.
Fuel pump control
Cut the 1,5 mm
2
BLACK/YELLOW wire with SILVER references in the light blue fuel
pump relay, on the right, in the fuse box.
STARTER
+50:
Cut the 1,5 mm
2
WHITE/GREEN wire in the wiring harness that comes out of the
ignition switch.
BONNET SWITCH
Install an additional switch on the headlight support plate, near the bonnet bumper
rubber on the driver’s side.
DOORS SWITCH
Connect to the 1 mm
2
RED/WHITE wire with SILVER references in the wiring harness
that comes out of the 12 way white connector of the central locking unit located behind
the lateral panel of the driver’s side, near the bonnet release lever.
BOOT SWITCH
Connect to the 1 mm
2
RED/SILVER wire located in the connector that comes out of the
boot’s interior lamp.
Note: This information is not binding, therefore it must be considered only an example for installation purposes that must be executed
as per the instructions given on the product installation manual.
nipri97gbb.doc
[ Pobierz całość w formacie PDF ]